Z-Eurocard Interface Connector; Figure 2.1: Z-Eurocard Dimensions - ashtech Z-sensor Operation Manual

An external two-color LED can be connected to the board by connecting the common
cathode to ground, and the anodes connected to the LED-GRN and LED-RED pins.
100-ohm resistors are in series with the output pins.

Figure 2.1: Z-Eurocard Dimensions

Figure 2.2 shows the 64-pin DIN male power/input/output interface connector (this
board is also available with a 64-pin straight header).
Figure 2.2: Z-Eurocard Interface Connector
10 Z-Sensor and Z-Eurocard Operation Manual