Pager Lx4 Plus / Lx4 Advanced - Motorola LX2 plus Service Manual

LX2 plus / advanced and LX4 plus / advanced
4.2 LX4 plus / LX4 advanced
4.2.1 Removing/ Replacing The Battery
•
Slide the door lock away from the battery door (refer to Fig. 1).
•
Slide and open the battery door as shown in figure 1.
•
Remove the battery.
•
Replace the battery with correct polarity (+ and – markings).
•
Close and slide back the battery door. Slide the door lock to its fully locked position.
4.2.2 Removing/ Replacing The Battery Door And Back Housing
•
Unlock the battery door (refer to Fig. 1).
•
Slide and take off the battery door (refer to Fig. 1).
•
Use a slotted screw driver (or similiar) to push the housing latch a few millimetres
away from the housing (near to the positive battery contact of the battery compartment
(Fig. 2). Move it a little upwards, remove it from the housing and pull it away in the di-
rection of the arrow (refer to Fig. 3).
•
Use tweezers (or similiar) to unlock the catch on the back housing from the front
housing (refer to Fig. 4).
•
Separate the back housing from the front housing (refer to Fig. 5).
•
Start re-assembly with the housing latch (refer to Fig. 6). Then align the back housing
with the front housing (refer to Fig. 5) and press together until the catch locks.
4.2.3 Removing/ Replacing The Receiver Board
•
Open the housing as previously described.
•
Gently pry the receiver board up and away from the decoder board (refer to Fig. 7).
•
To replace the receiver board, align the interconnect socket and plug (refer to Fig. 8)
and press the boards together. Do not misalign the shock pad!
•
Re-assemble as described above.
Fig. 1
B2270901 Content is subject to change without notice!
Fig. 2
20