Table of Contents
Advertisement
Set method: refer to chapter 4.3.1. Motion detect
Note:"Advanced" button is the same as rightclick.
4.3.5 Alarm output
Refer to chapter 3.5.4.
4.3.6 Abnormal
Analysing and inspecting current software and hardware of the device: When some abnormal events
happen,the device will make a relative answer such as show message and buzzer.
【Event Type】
【Enable】
【Show message】
【Buzzer】
4.4 System setup
Set the system parameters such as General,Encode,NetWork,NetService,GUI display,PTZ
config, RS232 and Tour setup.
Picture 4.12 Abnormal
selecting abnormity you want to inspect
Select it to make sure abnormal function workable
Automatically alarm cue dialog box come out of the main screen
Device will have two long nosie "di di" while alarm is happening
Page 36
Advertisement
Table of Contents
