Table of Contents
Advertisement
【Interval】Only one alarm signal is turned on even there are several motion detect signals in the set
interval.
【Alarm output】 Start the external equipment of corresponding linkage alarm when the motion detect
alarm is turned on.
【Delay】Delay a few moments and stop when the alarm state is turned off. The range is 10~300
seconds.
【Record channel】Choose the recording channel (multiple option supportive). Trigger the video
signal when the alarm is turned on.
Note:Set in the [recording setup] and perform the linkage recording. Start detecting video files
in the corresponding time section.
【Tour】■ means that the selective channel is single window alternate patrol preview. The interval is
set in the [MainMenu]>[System] > [Tour].
【Snapshot】Choose record channels,when alarm happens,system triggers related channels for
snapshot signal.
Note:For
Snapshot
MainMenu->Record->Record config,
【PTZ Activation】Set the PTZ activation when the alarm is turned on.
Note:PTZ activation is set in the [shortcut menu] >[ PTZ control]. Set the patrol between spots,
trail patrol and so on.
Picture 4.6 set the time section
activation,pls
go
to
Page 33
set
period,detect
and
alarm
enable
at
Advertisement
Table of Contents
