Weslo WLTL49907.0 User Manual page 8

5. While a second person holds the console as-
sembly near the Handrail (20), attach the
ground wire to the indicated hole in the Handrail
with a Ground Screw (33).
6. While the second person continues to hold the
console assembly, locate the wire underneath
the console assembly.
Connect the wire from the console assembly to
the Wire Harness (77). See the inset drawing.
The connectors should slide together easily
and snap into place. If the connectors do not
slide together easily and snap into place, turn
one connector and then try again. IF THE CON-
NECTORS ARE NOT CONNECTED PROP-
ERLY, THE CONSOLE MAY BE DAMAGED
WHEN THE POWER IS TURNED ON. Insert
the connectors downward into the Handrail (20).
7. Set the console assembly on the Handrail (20).
Be careful to avoid pinching any of the
wires. Make sure that the ground wire (see
step 5) and the wire from the console assem-
bly (see step 6) are in the indicated channel.
Hand tighten five Screws (3) into the Handrail
(20) and the console assembly. Do not put
Screws into the two indicated holes. Start all
five Screws, but do not tighten them yet.
5
20
6
Wire
77
Console
Assembly
20
7
Console Assembly
Channel
20
3
No Screws
8
Ground
Wire
33
Hole
Console
Assembly
77
3
3