Using Your Compact Oscillating Ceramic Heater - Sunbeam HE2105 Instruction Booklet

Using your Compact Oscillating
Ceramic Heater
1.Place the heater on a flat level surface and
ensure that the air intake and outlet are
clear of obstructions.
2.insert the plug into a 230/240V power
outlet and turn the power on.
3.The power on light and lCD screen will
illuminate.
NOTE: When the heater is switched on it
will be automatically set to the Standby
mode.
4.Press the mode button to select the
desired setting, as follows. Each time you
press the mode button it will scroll through
the various settings.
LOW – low heat setting
high – high heat setting
AuTo – for operating the electronic
thermostat
FAN – for fan only operation
without heat
STANDby – the heater remains inactive
when in this mode
NOTE: The fan speed will not change when
the mode is changed from low to high.
5.To switch the heater off, press the mode
button until the standby mode is set and
switch the power off at the power outlet.
6
Setting the electronic thermostat
The electronic thermostat allows you to set
the precise temperature. Once the desired
temperature level is reached the heater will
cycle on and off to maintain it.
1.Press the mode button until the AuTo
mode is displayed. The lCD screen will
display the ambient room temperature.
2. Set the desired temperature by turning the
thermostat dial. The selected temperature
will appear on the lCD screen.
NOTE: The temperature range is from
15ºC to 30ºC.
3.when the room temperature reaches
the set temperature the heater will
automatically turn off. The fan will
continue running for 15 seconds to cool
the heater. The unit will only turn on when
the room temperature falls below the
preset temperature.
NOTE: It is normal for the heater to cycle
on and off as it maintains the preset
temperature. To prevent the unit from
cycling, raise the thermostat setting.