Removing The Motor - Frank COBRA C Operating Instructions Manual

6.2

Removing the motor

Caution!
Injury to the operator or other persons could occur or damage could occur if the machine
starts up unintentionally. Disconnect the machine from the power supply before working
on the machine!
Instructions:
1. Make sure that the motor switch is in the off position and that the mains cable is
disconnected from the motor plug.
2. Unscrew the knurled nut from the belt guard and open the belt guard.
3. Loosen the lock nut (2) on the belt tension screw.
4. Turn the belt tension screw (1) counterclockwise. This will lower the motor and release the
tension on the belts.
5. Remove the belts.
12
Operating instructions
Parquet floor sander COBRA C
with gentle lifting lever