Operation Controls - Windsor Voyager 2 VGR2 Operating Instructions Manual

WWW.MANUALS.WS
1. Brush Height Adjustment. Raises and adjusts
the height if the brush.
2. Vac Shoe Lift Lever. Lifts the vac shoe up or
down and switches vac motor off and on.
3. Battery Charge Meter. Indicates the level of
charge that the batteries are holding.
4. Main Power Switch. Turns ON and OFF the
machine.
5. Drive Handle Control Connection. This is
where Drive Control Connection Assembly is
attached to rear panel.
6. Drive Motor Circuit Breaker. 16 amp Protects
the dirve motor mechanism.
7. Vac Motor Circuit Breaker. 35 amp Protects
the vacuum motors.
8. Brush Motor Circuit Breaker. 15 amp
Protects the brush motor.
9. Accessory Tool Hookup. Used for various
auxiliary cleaning tools.
10. Spray Position Switch. Controls the spray
adjustment between manifold and accessory
tools.
11. Hour Meter. Records the use time.
12. Pump Switch. Turns ON and OFF the pump
1
4
WWW.MANUALS.WS
3
DRAIN
VOYAGER DRIVE CONTROLS
1. The speed the machine will travel is regulated by
the knob located on the controls which are found
on the main handle. Turn the knob to the right to
increase the speed of the machine.
2
2. Squeezing one or both of the control levers will
propel the machine forward are the selected
speed.
3. Releasing both control levers will stop the
machine.
4. Pressing forward on the levers moves the
machine backwards at the selected speed.
VGR2 98953 12/18/01

OPERATION CONTROLS

SEE BELOW
SIGHT
FILL
TUBE
TO VAC SHOE
40
GAL
30
GAL
20
GAL
10
GAL
5
GAL
7