Before Requesting Service - Panasonic NN-CS597S Operating Instructions Manual

The oven causes interference with my TV.
Steam accumulates on the oven door and
warm air comes from the oven vents.
PROBLEM
Oven will not turn on.
Oven will not start cooking.
The word "LOCK" appears in the
Display Window.
The oven stops cooking by
microwave and "H97" or "H98"
appears in the display window.
"DEMO MODE PRESS ANY KEY"
appears in the display window.
The fan motor continue operating
after cooking is over.
IP1479_38S71CP_Eng_02_071107.indd Sec1:40 IP1479_38S71CP_Eng_02_071107.indd Sec1:40

Before Requesting Service

These things are normal:
Some radio and TV interference might occur when you cook with the microwave
oven. This interference is similar to the interference caused by small appliances
such as mixers, vacuums, blow dryers, etc. It does not indicate a problem with your
oven.
During cooking, steam and warm air are given off from the food. Most of the steam
and warm air are removed from the oven by the air which circulates in the oven
cavity. However, some steam will condense on cooler surfaces such as the oven
door. This is normal. After use, the oven should be wiped dry (see page 39).
POSSIBLE CAUSE
The oven is not plugged in securely.
Main circuit breaker or main fuse is
tripped or blown.
There is a problem with the outlet.
Oven Circuit Breaker is tripped.
The door is not closed completely.
Start button was not pressed after
programming.
Another program is already entered into
the oven.
The program is not correct.
Stop/Reset Pad has been pressed
accidentally.
The CHILD SAFETY LOCK was
activated by pressing Start button 3
times.
This displaying indicates a problem with
the microwave generation system.
The oven is in demonstration mode.
The fan motor is cooling the electric
components.
40
REMEDY
Remove plug from outlet, wait 10
seconds and re-insert.
Reset main circuit breaker or replace
main fuse.
Plug another appliance into the outlet to
check if it is working.
Reset Oven Circuit Breaker to "I"
position.
Close the oven door securely.
Press Start button.
Press Stop/Reset Pad to cancel the
previous program and enter new
program.
Program again according to the
Operating Instructions.
Program oven again.
Deactivate LOCK by pressing Stop/
Reset pad 3 times.
Please contact an authorised Service
Centre (see page 41).
Press Timer/Clock pad 4 times to exit
the mode.
It is normal.
2007-11-7 @Tom@ 11:34:05 2007-11-7 @Tom@ 11:34:05