To Clamp The Quick Release Fastener; Quick Release Fastener Operation; Universal Mounting System On Select 6 Ultra - Pride Jazzy Select 6 Owner's Manual

Quick Release Fasteners: The seat is secured to the seat
post with a quick release fastener. The quick release fas-
tener consists of a bolt, a lever, and a nut. See figure 14.
The lever has a cam on the end that allows it to clamp into
place. The quick release fastener has two states: clamped
and unclamped. When the lever is open, the quick release
fastener is unclamped. When the lever is closed, the quick
release fastener is clamped.

To clamp the quick release fastener:

1. Make sure the lever is in the open position.
2. Turn the nut clockwise until it is snug.
3. Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut counterclockwise one-
quarter or one-half turn.
Seat Installation (Select 6 Ultra only)
It may be necessary to install the seat either prior to initial
operation or after transporting your power chair. Most seats
are attached to the power base with the Universal Mounting
System (UMS). The UMS consists of universal parts that
may be attached to any medium-back or high-back seat,
regardless of seat width or seat depth. The two main com-
ponents are aluminum extrusions mounted to the seat base.
These extrusions attach to a pair of trapeze bars that are
mounted to the power base. See figure 15.
WARNING! Do not pick up the seat
frame by the armrests. They are free to
pivot, and you may lose control of the
seat if they do so.
To install the power seat:
1. Tilt the seat back and slide the rear extrusion onto the
power seat base.
2. Lower the front extrusion onto the power seat base
until the seat locks into place.
3. Flip down the seat latch safety. See figure 16.
4. Connect the power seat connector and controller har-
ness to the power base.
5. Lift the armrest straight up, then route the controller
harness and secure with wire-ties as shown in figure 18.
24
I V . A S S E M B L Y
www.pridemobility.com
UNCLAMPED
BOLT
LEVER (OPEN)
Figure 14. Quick Release Fastener Operation
Figure 15. Universal Mounting System on Select 6 Ultra
CLAMPED
LEVER (FULLY CLOSED)
NUT
CAM
REAR EXTRUSION
SEAT LATCH
SAFETY
FRONT EXTRUSION
Jazzy Select Series