Configuring For A Block Of Static Ip Addresses - ActionTec GT701-WG User Manual

11. Click "Save and Restart" at the bottom of the screen.
12. The "Save and Restart" page appears. Click "Save and Restart" to save the set-
tings changed in the Change Admin Username/Password screen.
The Gateway has been configured to support a single static
Power light stops blinking, the Gateway is ready for use.

Configuring for a Block of Static IP Addresses

To set up the Gateway to use a block of static
☞
Note: To complete this procedure, you must have access to the
Internet Service Provider (
been provided, contact the
1. Open the Web browser. In the address bar enter:
then press Enter on the keyboard.
2. The "Main Menu" screen appears. Select Setup/Configuration.
Chapter 5 Setting Up Static IP
) worksheet. If no worksheet has
ISP
.
ISP
http://192.168.0.1
57
address. Once the
IP
addresses:
IP