ActionTec GT701-WG Quick Start Manual

1
Connect the Gateway to a Computer
Step 1 Get the Wireless DSL
Gateway from your DSL
Quick Start Kit.
Wireless DSL Gateway
Step 2 Get the Black Bag
and remove the Power Cord
from the bag.
Power Cord
Step 3 Plug the smaller end
Black Port
of the Power Cord into the
Black Port marked "Power" on
the back of the Gateway.
Power
Cord
Step 4 Plug the larger end of
Power
the Power Cord into a Power Outlet
Power
Outlet.
Cord
Step 5 Confirm the Power
Light on the Gateway is SOLID
Green.This may take 30 seconds.
Power Light on Wireless DSL Gateway
Note: The DSL light will blink.
Step 6 Get the Yellow Cable.
Yellow Port
Step 7 Plug one end of the
Yellow Cable into the Yellow
Yellow
Cable
Port on the back of the
Wireless DSL Gateway.
Step 8 Make sure that your
computer is turned ON.Then
plug the other end of the Yellow
Cable in the Ethernet Port on
the back of the computer.
An Ethernet Port looks similar
to a regular Phone Jack, but is
slightly larger.
Step 9 Confirm that the
Ethernet light on the Gateway
is Green. This may take a few
moments.
Ethernet Light on Wireless DSL Gateway
Note: If the Ethernet Light does NOT turn green, make sure the Yellow Cable is
properly connected on both ends.
Step 10 Get the Green DSL
Green Port
Cable out of the Black Bag.
Green
Cable
Step 11 Plug one end of the
Green Cable into the Green
Port on the back of the
Gateway.
Step 12 Plug the other end of
Phone
Jack
the Green Cable into the Phone
Green
Jack closest to your computer. Cable
Step 13 Confirm that the
Power and DSL Lights are
SOLID Green. This may take
up to 60 seconds.
Power & DSL Lights on Wireless DSL Gateway
Note: If the DSL Light is NOT solid green, make sure you received notification
from your DSL Internet Service Provider that your DSL service is On.
2
Install the Phone Filters
What are Phone Filters? Phone Filters separate the DSL signal
from the voice signal, allowing you to talk on the telephone
and be online at the same time.
All Devices with the same phone number as your DSL Line
require Phone Filters. This includes telephones, fax machines,
caller ID boxes, satellite TV receivers and answering machines.
Step 1 Unplug your Telephones
(or other devices) from their
current Phone Jacks.
Step 2 Open the Clear Bag
and remove the Phone Filters
from the bag.
Note: The number and type of Phone Filters included in this kit may vary.
Step 3 Plug a Phone Filter into
Phone
every Phone Jack in your house Jack
with the same phone number
as your DSL Line, and a
telephone (or other device)
Phone
connected to it.
Filter
If you need additional Phone
Filters, contact your DSL Internet
Service Provider.
Step 4 Plug one end of the
Phone
Phone
Phone Cord into the Phone Jack
Filter and keep the other end
attached to the telephone (or
other device).
Phone Phone
Cord Filter
Step 5 Make sure you did
NOT put a Phone Filter on the
Green DSL Cable. It should be
plugged DIRECTLY into the
Yellow
Phone Jack.
Cable
Power
Cord
Make sure your setup looks DSL
Cable
EXACTLY like the picture to the
right.
Flip this Quick Start Guide over to continue
QS674/0104 Part No: 0530-0470-000