CaptionCall 57Tx Setup Manual page 11

Start It Up...
Do You Want to Go Wireless?
If you want to use a wireless connection
for your CaptionCall phone, you will have to
set up the wireless feature before you can
make captioned telephone calls.
To do so, find your CaptionCall User
Guide now and then follow the steps in the
Getting Started section under the heading
"Setting Up the Wireless Network Feature."
After you've connected to your wireless
network, you can come back to this page
to continue setting up the phone.
setup guide
Wait for CaptionCall to Start Up
After you connect the power cord to the wall outlet, your CaptionCall
phone will begin starting up. Just wait briefly while the phone calibrates
the touch screen display and starts up.
Do Not Touch the Display
Because the CaptionCall display screen is sensitive to touch, try not to
touch the display immediately after you connect the phone to power.
Your CaptionCall phone calibrates its display screen while it is starting up.
If you touch the screen, the calibration process may be interrupted. To
help you remember, the phone will briefly show a message on the display
screen that asks you not to touch the display as the phone is starting up.
If You Do Accidently Touch the Display...
No harm will be done to the phone if you accidently touch the display
while it is starting up. You might notice that the screen is a little bit less
sensitive to your touch if the calibration was interrupted.
If you do touch the display screen by mistake, no worries. Just unplug the
power cord from the wall outlet and then plug it back in again. Your
CaptionCall phone will start up again and calibrate its display normally.
11