Front And Rear Panels; Troubleshooting - Arris VAP2500 Quick Start Manual

Installation
The VAP2500 enables you to transmit multiple standard- and high-definition video streams throughout your home
wirelessly. You can enjoy a full range of video services and applications without having to run wires, lay cables,
or drill holes. The VAP2500 uses one-button, Wi-Fi Protected Setup (WPS) technology to ensure easy, reliable
installation.
Front Panel
Rear Panel
POWER LED is red-
orange
Solid green WPS LED
Flashing green WIFI LED Failure to connect with AP . Call for technical support.
Power Green = The VAP2500 is on.
Red/orange = Device has failed the power on self test.
Off = The VAP2500 disconnected from its power source.
WiFi Red = Bandwidth is available for less than one device.
Green = Bandwidth is available for more than one device.
Fast flashing green = No client connected with an access point (access point
only).
Amber = Bandwidth is available for only one device.
Off = No power or in POST.
WPS Blinking Green = During WPS pairing (which has a two minute time out)
then both devices' LEDs slow flash. If an access point has just finished
pairing with a client and a second WPS session is started with another
client, the access point will start its second slow flashing green after the
30 second time.
Solid Green = WPS pairing is successful; the LED will turn solid green
for 30 seconds and then turn off.
Solid Amber = WPS pairing is unsuccessful, WPS LED stays solid amber.
Off = WPS between access point and client was successful, or two
minutes time out.
WPS WPS button; invokes WPS processing when the button is pressed and
released.
Reset Button
Ethernet Port
Power
Connector

Troubleshooting

If any of the POST checks fail then the POWER LED will illuminate to give a red-orange color. If the
red-orange POWER LED is on, then the unit is broken and needs to be replaced.
WPS association has failed (LED remains solid green for more than 30 seconds). If WPS is
successful then the LED immediately turns solid green, stays solid green for 30 seconds, then
turns OFF . Repeat step #4 under Connect the Wireless Client .
Resets the VAP2500 to its default settings.
Connects to the Ethernet-equipped Home Gateway.
Provides power to the VAP2500.