Installing - Arris VAP2500 Quick Start Manual

Installing Your VAP2500
Follow the instructions below to install your Wireless Access Point and Client.
Step 1: Connect the Wireless Access Point
1. Connect one VAP2500 unit to your Gateway using the provided six-foot black with yellow tips Ethernet cable. Before
you connect the VAP2500, ensure the Gateway is powered on.
2. Connect the power adapter to the VAP2500 and plug the adapter into a wall outlet. You'll see the unit's Power LED
light go on, indicating the unit is powered
Step 2: Connect the Wireless Client
1. Connect one VAP2500 unit to your set-top using the provided six-foot black with yellow tips Ethernet cable. Before you
connect the VAP2500, ensure the set-top is powered on.
2. Connect the power adapter to the VAP2500 and plug the adapter into a wall outlet. You'll see the unit's Power LED
light go on, indicating the unit is
3. Wait 60 seconds after powering the client, and then press and hold the WPS button on the front panel for two
seconds. You will then have two minutes to activate the WPS on the access point.
4. Press the WPS button on the access point. If pairing is successful the WPS will light solid green for 30 seconds and
then turn off.
5. Turn on TV at the client and view video. See Troubleshooting if this fails.
Installing Additional clients
Repeat steps 2-5 above.
powered.