Care And Operation - Lennox Bella Installation And Operation Manual

CARE AND OPERATION

Simple Operating Instructions
. Preparation
a] Check hopper and remove
any materials from hopper
and auger
b] Check cast burn pot for
proper fit (ensure cast burn
pot is set securely in the base
- see Figure 34)
c] Check door gasket and door
latch to ensure tight seal
(see Figure 31)
d] Connect power cord to
grounded power supply
outlet
FAN
FAN SPEED
Convection
(room air)
Control Dial
MIN
IGNITION / HEAT CONTROL
LOW
OFF
FIRST TIME USE
3. Priming the Auger
(Optional)
a] Fill hopper with pellets
Note: Use quality grade pellet
fuel
b] Turn the "IGNITION/HEAT
CONTROL" dial to begin the
ignition sequence
e] When pellets begin to drop
from feed tube into burn pot,
turn dial to "OFF"
4. Stove is now ready for
start-up
LCD Status
Screen
HEAT
MAX
HIGH
Ignition / Heat
Control Dial
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
1. Start
5. To Start Your Stove
a] Check hopper, and fill with
pellets, if necessary.
b] Turn the "IGNITION/HEAT
CONTROL" dial to the
desired heat setting.
The convection blower will
not turn on until the stove
has reached operating tem-
perature.
6. Pellets will drop into burn
pot and stove will light
in approximately 3 to 7
minutes
Does the Stove Light?
No
7a. Follow the troubleshooting
section in this manual
Does the Stove Light?
No
Contact your Lennox Hearth
Products dealer for further
assistance
7. Once the ignition sequence
is complete, the stove will
enter "heating" mode and
run at the chosen setting
8. After approx. 5 minutes
adjust draft adjuster if
necessary to obtain a
bright vibrant flame.
Notes:
• If the draft adjuster is too
far inward the flame will
be lazy/sooty and the fuel
will pile up in the burn pot
(see Page 10).
• If the draft adjuster is
too far outward the flame
Yes
might burn erratically.
See Page 21 for further
instructions on adjusting the
draft adjuster using thermo-
stat vs manual modes.
9. To Turn Off Pellet Stove
a] Turn the "IGNITION/HEAT
CONTROL" dial to the "OFF"
position.
Yes
b] Stove goes into cool-down
mode. Pellets stop feeding
and the fire goes out within
2 minutes after the auger
is shut off, the room air
blower and exhaust blower
will automatically shut off in
approximately 15 minutes.
10. Thank you for purchasing a Lennox
Hearth Products Pellet Stove
END
19