Griddle Surface; Limited Calibration - Keating Of Chicago Griddle User Manual

A. Griddle Surface
With proper care, the MIRACLEAN
unique cooking properties will last for many years.
However, nicks or dents in the griddle surface may
cause the griddle surface to lift from the depressed
area. If nicks are close together, the surface may raise
and be torn when a spatula or scraper is used. Care
should be taken, as the damage done is irreparable.
See Figure 3-3 on page 4.
Damage done to the MIRACLEAN
irreparable and is not covered under Keating Warranty.
B. Limited Calibration for 208-240 Volt Units (Less
than 50°F difference)
You will need: One standard flat blade screwdriver
One accurate griddle thermometer
1. Set thermostat to 300°F.
2. Allow thermostat to cycle three times.
3. Locate inverted "V" on front of griddle plate above
to locate thermostat
thermometer on plate over bulb half way toward
rear of griddle.
Figure 4-1
Thermostat calibration
4. If calibration of griddle is found to be less than 50°F
off, simply loosen four dial plate retaining screws
(See Figure 4-1), rotate dial plate to match
thermometer reading and tighten screws.
NOTE: Calibration is not covered under warranty.
® surface and its
® surface is
bulb position. Place
CLEANING
Proper care should be taken to fully clean the griddle
on a regular basis.
DISCONNECT ELECTRIC POWER
WARNING
SOURCE BEFORE CLEANING.
A.
any grease build-up on the switches
and thermostat knobs.
NOTE: If grease gets into the body
of the switch or thermostat, it may
Disconnect all power
before servicing.
cause it to fail.
IF GREASE GETS INTO THE
WARNING
BODY OF
Gas Burns Shock
THERMOSTAT, IT MAY CAUSE
ELECTRICAL SHOCK.
B.
and sides of the cabinet should be
kept clean for sanitary and safety
Improper installation
can cause damage,
reasons.
injury or death.
See page 5 "Cleaning the Griddle"
6
CONTROL PANEL - Clean
THE SWITCH
CABINET - The front, back
OR