Norcold 682 Installation And Operating Instructions Manual page 14

Figure 22
Figure 23
ALIGNMENT OF THE DOORS
12. Align the upper door with the lower so that
there is a parallel gap between the doors and
around the frame. Adjust the doors to the cabi-
net so the gaskets seal but do not bind. Tighten
the screws holding the hinge brackets in place.
13. Door Seal: The door seal can be checked by
closing the door on a 1" x 6" strip of paper. A
slight drag should be noticed when the paper is
pulled out from between the gasket and the
cabinet. Repeat the process around all four
sides of the door. If the door does not seal
properly, readjust the hinge brackets.
14. Position the travel latches so that they secure
the doors when closed but does not prevent the
doors from closing properly. Tighten the two
screws in each travel latch.
15. Replace the juice rack and storage bins into
the door. Make sure that the milk bins (wider
storage bins) are installed in the lowest door
position.
13