Norcold 682 Installation And Operating Instructions Manual page 13

hole plugs from each of the corresponding
holes on the opposite side of the refrigerator.
Relocate them in the two holes just exposed by
the removal of the latches. Using the two
screws, attach each latch in the new position so
the tab points towards the opposite side of the
refrigerator. Do not tighten screws completely.
(See Figure 20)
Figure 18
REMOVING AND RELOCATING THE HINGE
BRACKETS
5. Remove the middle hinge bracket by using the
#2 Phillips screwdriver and taking out the three
screws holding it in place. Next, with fingernails,
lift and remove the three hole plugs on the op-
posite side corresponding to the center hinge
Figure 20
location. Relocate them in the holes just ex-
posed by the removal of the hinge bracket. Us-
ing the same screws, attach the hinge bracket
to the refrigerator where the hole plugs pre-
viously were. Do not tighten screws completely.
(See Figure 19)
Figure 19
6. Remove the top hinge bracket and reposition it
in the opposite bottom corner. Use the same
Figure 21
technique as outlined in Step #5.
7. Remove the bottom hinge bracket and reposi-
tion it in the opposite top corner. Use the same
technique as outlined in Step #5.
RELOCATING THE TRAVEL LATCHES
8. Remove both travel latches by taking out the
two screws holding each to the refrigerator. Use
the #2 Phillips screwdriver. Remove the two
9. Turn the door over so that the end previously at
the bottom is now at the top. Relocate the bot-
tom of the door on the bottom hinge pin shoul-
der. Close door and align holes in top hinge
brackets. The magnetic gasket will hold the
door in place. Before reinstalling the top door,
check to insure that the spacer is in place. (See
Figures 21 and 23C)
10. Reposition the upper door in a similar manner
as described in Step #9, except the top of the
door must be engaged into the hinge pin
shoulder before setting the door in place.
(See Figure 22)
11. Starting at the top, replace the hinge pins using
the slotted screwdrivers as in the removal pro-
cedure. Tighten all screws.
12