Installation And Operating Instructions; Checks Before Installation; How To Remove Panels - Hoshizaki KMD-410MAH Instruction Manual

II. Installation and Operating Instructions
A. Checks Before Installation
1. Install in accordance with all applicable national, state, and local
regulations.
2. Remove all shipping cartons, tape, and packing material. If any are left in
the icemaker, it will not work properly.
3. Ensure all components, fasteners, and thumbscrews are securely in place
after installation.
1) Remove the panels to prevent damage when installing the icemaker. (See "B. How to
Remove Panels.")
2) Remove the package containing the accessories.
3) Remove the protective plastic film from the panels. If the icemaker is exposed to the sun
or to heat, remove the film after the icemaker cools.
4) Check that refrigerant lines do not rub or touch lines or other surfaces, and that the fan
blade turns freely.
5) Check that the compressor is snug on all mounting pads.
6) See the nameplate on the rear panel, and check that your voltage supplied corresponds
with the voltage specified on the nameplate.
7) This icemaker can be installed on a storage bin or dispenser unit 22" wide or wider. If
using a storage bin, HOSHIZAKI STORAGE BIN, Model B-300 series is recommended.
B. How to Remove Panels
* Front Panel: Loosen the screws. Lift up and towards you.
* Top Panel: Lift up at front slightly, push rearward and lift off.
* Side Panel (R): Remove the screw. Slide forward slightly and lift off.
* Front Insulation: Lift up slightly, and pull towards you.
* Top Insulation: Push up at front corner, and pop off.
IMPORTANT
- See Fig. 1
5