Bin Control Installation - Hoshizaki KMD-410MAH Instruction Manual

E. Bin Control Installation
1) Remove the front panel, then remove the front insulation.
2) Loosen the two thumbscrews securing the pump motor bracket. See Fig. 3.
Discharge
Hose
3) Disconnect the discharge hose.
4) Disconnect the pump motor connector and float switch connector from the side of the
control box.
5) Keep pushing up the snapping tab at the right side of the pump motor bracket.
6) Pull out the water tank, cube guide, pump motor bracket, pump motor and float switch
together. See Fig. 4.
Snapping Tab
Pump Motor Bracket
Fig. 3
Cube Guide
Fig. 4
8
Float Switch
Connector
Pump Motor
Connector
Thumbscrews
Pump Motor
Float Switch