Table of Contents
Advertisement
2. Bin Control Installation
Before operating the icemaker, the bin control must be installed. Failure to properly
install the bin control could result in ice backup and icemaker damage.
1) If not already removed, remove the front panel, top panel, and right side panel.
2) Remove the bin control from the compressor compartment. See Fig. 3.
3) Remove the bin control extension bracket from the upper taper collar and lower it into
the access hole and secure it on the lower taper collar. See Fig. 4. Note: Be sure to
secure the bin control extension bracket onto the lower taper collar.
Upper Taper Collar
Access Hole
4) Remove the switch mount and thumbscrews from the accessory bag. Open the ice
storage bin door and install the switch mount to the bin control extension bracket.
See Fig. 5.
Thumbscrews
NOTICE
Bin Control
Bin Control
Extension
Bracket
Lower Taper Collar
Fig. 4
Compressor Compartment
Fig. 3
Bin Control
Extension
Bracket
Switch Mount
Fig. 5
17
Access Hole
Thumbscrews
Advertisement
Table of Contents
