Firmware Upgrade - Incom ICW-1000 Global Admin Manual

Firmware Upgrade
There are two ways to set Firm ware update. The first one is input address in menu via the key
pad; another one is upgraded by Auto‐provisioning server automatically.
→ 8. Admin Menu → Enter Password → 4. Firmware upgrade
1 Select "4.Firmware Upgrade" in System Settings' menu
2 Select protocol, Enter IP and File name.
Enter IP or DNS in "Input IP or DNS"
Enter Firmware file name in "Input File Name"
i.e Input IP or DNS: 192.168.10.10
Input File Name : example.zip
Do not unzip the Firmware zip file which was
provided by Unidata. Just load the zip file on the TFTP or
HTTP server. The ICW‐1000G pulls its configuration and
upgrade when you turn the phone off and on.
If the original zip file name is too long to input on
the phone, you can replace it with simple one like 240.zip
3 Firmware will be updated.
It cannot be upgraded if the Firmware version is same or
less than current version. Make sure that the server
should be root directory.
Don't tune the phone off during update. Make
sure
battery is enough. Power off during update will cause
h lf i
37