Table of Contents
Advertisement
DVD mechanism assembly and parts list
CLAMPER SA
NOTES:
1.Attach the MAGNET to the CLAMPER.
2.Lock the MAGNET and BACK YORK to the CLAMPER firmly
with its 3 hooks.
3.Make sure that none of the 3 hooks of the CLAMPER is
broken/ bent/ changed in shape.
26
25
24
CLAMPER SA
23
We cannot supply parts that are not
in the Parts List, as they are not
exchangeable because of the
design feature. Please handle the
replacement with Mechanism
Assembly Units.
19
18
3-4(No.YD058)
28
3 hooks
21
21
3
20
2
17
15
8
17
8
4
28
27
22
[FIG-3] LOWER CASE/ SLIDER Grease Application Point
3
3
21
NOTES:
1
10
9
11
14
7
13
6
b
c
12
17
8
LOWER CASE: 9 Grease Application Points
5
8
[FIG-3] GEAR Attachment
NOTES:
1.Attachment order of the GEARS is as follows,
[GEAR 2]
[GEAR 3]
[GEAR 1]
Be sure to adjust the Phase of GEAR 2 and GEAR 3.
NOTES:
<GEAR 2 Phase Mark>
<GEAR 3 Phase Mark>
Make
mark as a Phase
Adjustment Mark
16
Make the salient of the outer circumference
of GEAR 3 as a Phase Adjustment Mark.
Bl oc k No.M 2 M M
[FIG-1] LOADING MOTOR - PULLEY Press Fitting.
-0.1
MOTOR PULLEY Height should be
5.35
-0.4
(Measurement between the top part of the PULLEY
and the top of the MOTOR Can)
6
-0.1
5.35
-0.4
5
[FIG-2] INSULATOR Attachment
NOTES:
1.Insert the INSULATOR firmly without mixing
up the top and bottom side.
2.After the attachment of the INSULATOR,
fasten the LOADER SCREW.
3.Be sure that the LOADER SCREW is not
fastened at an angle of improperly fastened.
DRAWING FROM
DIRECTION A
DRAWING FROM
DIRECTION B
SLIDER: 6 Grease Application Points
Type of Grease: TAG- 200R
Amount of Grease: 8
1mg each
1.After the attachment of the SLIDER to the LOWER CASE, pull
the SLIDER towards the SNAPFIT (left side). Apply the grease
to the points shown in the figure below.
2.Grease should be applied before the attachment of
TRAVERSE BASE SA.
LOWER CASE
SLIDER Grease Application Points
LOWER CASE
"a"
Type of Grease: TAG- 200R
Amount of Grease: 8
1mg each
Note: Application amount at area "a"
(left of PULLEY GEAR SHAFT) is 64
4mg.
NOTES:
3.Apply Grease in the center of GEAR Attaching SHAFT.
4.Apply Grease before attaching any kind of GEARS.
10
Correct Phase Adjustment
[PULLEY GEAR].
Each Phase Adjustment Mark
is on the straight line.
9
1
LOWER CASE
LOADER SCREW
INSULATOR
LOADER BKT
Advertisement
Table of Contents
