Keating Of Chicago Bumper Guard 14 IFM SE Service Instructions

S E R V I C E I N S T R U C T I O N S
www.keatingofchicago.com
Leg Channel
Instructions:
1. Remove bolts (A) and nuts (C) in rear of fryer using socket and wrench.
2. Remove bar currently in place (1/4"x1" bar stock).
3. Install bumper guard (B) in place of bar stock as shown above.
4. Reinstall bolts, nuts and spacers (A and C). NOTE: Keep loose until all four are in place.
5. Tighten bolts and nuts using socket and wrench.
Kit Includes:
Bumper Guard
Cabinet Side
A and C
(Qty 4)
View A-A
B
C
(Qty 4)
14 IFM SE BUMPER GUARD
Installation Instructions
Tools Needed:
7/16" socket & driver
7/16" open end wrench
View A-A
Rear view of
fryer
Spacers
A (Qty 4)
Enlarged View
part # 037532
1-800-KEATING
Qty. Description
A 4 Bolt 1/4-20
B 1 Bumper Guard
C 4 Nut 1/4-20
CAUTION: During
assembly of Item B,
sides of cabinet should
be parallel. Clearance in
mounting holes on
cabinet sides, leg
channels and bumper
guard will allow
adjustment when
attaching hardware.
Tighten bolts and nuts
at the end of installation.
BEFBumperGuard 6/04