Connecting To Pc (In Os Windows Xp); Pc With Ethernet Adapter; Obtaining Ip Address Automatically - D-Link DIR-620 User Manual

DIR-620 Multifunction Wireless Router Supporting 3G/2G, CDMA, WiMAX
with Built-in 4-port Switch
User Manual

Connecting to PC (in OS Windows XP)

PC with Ethernet Adapter

1. Make sure that your PC is powered off.
2. Connect an Ethernet cable between any of LAN ports located on the back panel of the router
and the Ethernet port of your PC.
3. To connect via a WiMAX, CDMA or 3G/2G network: connect your USB-modem to the
USB port, located on the back panel of the router.
4. Connect the power cord to the power connector port on the back panel of the router, then
plug the power adapter into an electrical outlet or power strip.
5. Turn on your PC and wait until your operating system is completely loaded.

Obtaining IP Address Automatically

1. Click the Start button and proceed to the Control Panel > Network and Internet
Connections > Network Connections window.
2. In the Network Connections window, right-click the relevant Local Area Connection
icon and select the Properties line in the menu displayed.
3. In the Local Area Connection Properties window, on the General tab, in the This
connection uses the following items section, select the Internet Protocol (TCI/IP)
line. Click the Properties button.
Figure 1. The Network Connections window.
Page 10 of 98
Installation and Connection