Rear Panel - Inter-m PA-6312 Operation Manual

Rear Panel

Rear Panel
1
OUTPUT
B
COM 43.8V(4 ) 70V(10.2 )
~
AC INPUT
220V 60Hz
FUSE : T8AL / 250V
4 5 6
1. SPE KER OUTPUT TERMIN LS
These terminals are used to connect speakers to the unit. You may select either 4
operation, or High Impedance operation at either 70V or 100V. Make certain the combined impedance of
the speakers is equal to or higher than the rated load impedance of the amplifier.
Refer to page 7 for minimum load impedance and output voltage.
2. LEVEL CONTROL
This knob provides continuous control of the amplifier's output level, from –12dB to 0dB (reference input of
0dB at 1V). Turning the knob clockwise increases the level, and turning it counter-clockwise decreases the level.
3. F N VENTS
These vents provide hot air flow out of the unit. It is important to keep them free of obstructions, to prevent
the unit from overheating. It is also important to operate the unit in a dust-free environment.
4. C POWER INPUT
Connect the supplied standard C input cable here.
5. FUSE HOLDER
This holder contains the C overload protection fuse. If the fuse has blown out, replace it with a fuse of the
same type and rating.
If the fuse continues to blow, refer servicing to a qualified service technician.
2
A
100V(20.8 )
BALANCED
INPUT
LINK
1V/10K
INPUT(ADJ)
HPF GROUND
ON OFF LIFT
12dB 0dB
FLOAT
7
PUBLIC DDRESS POWER MPLIFIER
ERI
JH09002-4007
PA-6348
AC 220V 60Hz
480W
600W
~
TEL : (02)3493-4120 5
FRAME
DC INPUT
24V
8 9
P -6312/6324/6336/6348
3
www.inter-m.com
or 8 conventional
5