Pro-Form PF 3.6 User Manual page 16

5. Follow your progress with the displays.
The track—When the
manual mode is se-
lected, a track represent-
ing 400 meters will ap-
pear in the matrix. As
you walk or run on the
treadmill, the indicators around the track will appear
in succession until the entire track appears. The
track will then disappear and the indicators will
again begin to appear in succession.
The lower left display—
As you exercise, the
lower left display can
show the elapsed time
and the distance that
you have walked or run.
The lower left display will also show the incline of
the treadmill each time the incline level changes.
Note: When a workout is selected, the lower left
display will show the time remaining in the workout
instead of the elapsed time.
The lower right dis-
play—The lower right
display can show the ap-
proximate number of
calories that you have
burned and the speed of
the walking belt. The display also shows your heart
rate when you use the handgrip pulse sensor (see
step 6).
The upper dis-
play—The
upper display
can show the
elapsed time,
the distance that
you have walked or run, the approximate number of
calories that you have burned, or the speed of the
walking belt. Press the Display button repeatedly
until the upper display shows the information that
you are most interested in viewing. Note: While in-
formation is shown in the upper display, the same
information will not be shown in the lower displays.
To reset the displays, press the Stop button, re-
move the key, and then reinsert the key.
6. Measure your heart rate if desired.
Before using the
handgrip pulse
sensor, remove
the sheets of clear
plastic from the
metal contacts on
the pulse bar. In
addition, make
sure that your
hands are clean.
To measure your heart rate, stand on the foot
rails and hold the pulse bar with your palms on the
metal contacts. Avoid moving your hands. When
your pulse is detected, a heart symbol in the lower
right display will flash each time your heart beats,
one or two dashes will appear, and then your heart
rate will be shown. For the most accurate heart
rate reading, continue to hold the contacts for
about 15 seconds.
7. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest setting
or you may damage the treadmill when you fold
it to the storage position. Next, remove the key
from the console and put it in a secure place.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the "off" position and
unplug the power cord. IMPORTANT: If you do
not do this, the treadmill's electrical compo-
nents may wear prematurely.
16
Contacts