Pro-Form PF 3.6 User Manual page 9

6. With the help of a second person, carefully tip
the treadmill onto its right side. Partially fold the
Frame (48) so the treadmill is more stable; do
not fully fold the Frame yet.
Attach a Base Pad (81) to the Base (85) in the
location shown with a Base Pad Spacer (104)
and an M4.2 x 25mm Screw (2). Then, attach a
Base Pad (81) in the location shown with only a
M4.2 x 25mm Screw (2).
Attach a Wheel (86) with the M10 x 50mm Bolt
(4) and the M10 Nut (33) that you removed in
step 1. Do not overtighten the Nut; the Wheel
must turn freely.
7. With the help of a second person, hold a Bolt
Spacer (79) inside the lower end of the Left
Upright (73). Insert a M10 x 96mm Bolt (5) with
an M10 Star Washer (8) into the Left Upright
and the Bolt Spacer. Repeat this step with a
second Bolt Spacer (79), M10 x 96mm Bolt
(5), and M10 Star Washer (8).
Orient the Left Upright (73) and the Left Upright
Spacer (83) as shown. Hold the Left Upright
Spacer and the Left Upright against the Base
(85). Finger tighten the M10 x 96mm Bolts (5);
do not fully tighten the Bolts yet.
Press a Base Endcap (82) into the Base (85).
With the help of a second person, tip the tread-
mill so that the Base (85) is flat on the floor.
8. Set the Console (87) face down on a soft sur-
face to avoid scratching the Console. Remove
the four M4.2 x 16mm Screws (12) and the two
M5 x 15mm Screws (64). Save all six Screws
for step 10.
Lift off the Pulse Support (109).
6
81
2
7
5
8
82 79
85
8
12
12
109
9
85
48
4
104
86
81
2
33
73
83
12
64
12
64
87