Adjusting Footplate Height; Spring Button Height; Bolt-In-Place Height - Invacare 9000XT Recliner Owner's Operator And Maintenance Manual

SECTION 4—FRONT RIGGINGS

Adjusting Footplate Height

Spring Button Height

NOTE:!For!this!procedure,!refer!to!FIGURE 4.2.
NOTE:!This!procedure!applies!to!the!swingaway!front!riggings!and!swingaway!elevating!legrest.
1. Remove!the!front!rigging!assembly.!Refer!to!Installing/Removing!Front!Riggings!on!
page 31.
NOTE:!Lay!the!front!rigging!assembly!on!a!flat!surface!to!simplify!this!procedure.
2. Pull!the!cam!lock!lever!up!to!unlocked!
position.
NOTE:!The!elevating!legrest!has!two!sets!of!
release!buttons,!one!set!above!the!other.!Each!set!
will!be!visible!one!at!a!time!allowing!finer!
footplate!height!adjustment.
3. Push!in!the!release!buttons!and!
reposition!the!footplate!assembly!to!the!
desired!height.
4. Ensure!that!the!release!buttons!fully!
protrude!from!holes!on!both!sides!of!
the!front!rigging!support.
5. Rotate!cam!lock!lever!down!to!locked!
position.
6. Repeat!this!procedure!for!the!other!
footplate,!if!necessary.
7. Reinstall!the!swingaway!front!rigging!assembly.!Refer!to!Installing/Removing!Front!
Riggings!on!page 31.

Bolt-In-Place Height

NOTE:!For!this!procedure,!refer!to!FIGURE 4.3!on!page!33.
NOTE:!This!procedure!applies!to!the!swingaway!footrests!and!swingaway!elevating!legrest.
1. Remove!the!swingaway!front!rigging.!Refer!to!Installing/Removing!Front!Riggings!on!
page 31.
NOTE:!Lay!the!front!rigging!assembly!on!a!flat!surface!to!simplify!this!procedure.
2. Pull!the!cam!lock!lever!up!to!position.
3. Using!a!screw!driver!to!hold!the!threaded!rivet!in!position,!remove!the!button!head!
screw!from!the!threaded!rivet.
4. Remove!the!threaded!rivet!and!button!head!screw!securing!the!footplate!assembly!to!
the!front!rigging!support.
9000 Series
Adjustment
Holes
Cam Lock Lever
NOTE:!Swingaway!footrest!shown.
FIGURE 4.2 Spring Button Height
32
Front Rigging Support
Release Button
Footplate
Assembly
Part No. 1056953