Table of Contents
Advertisement
Removing the existing flat panel monitor stand
Use the following steps to remove the existing flat panel monitor stand from your monitor:
1. Unplug the flat panel monitor and disconnect the power cord from the flat panel monitor power supply.
2. Carefully use a flat-blade screwdriver to pry the bottom of the cable cover 1 up and remove it. Save
the cable cover for later reinstallation.
Figure 1. Removing the cable cover, hinge cover, and stand cover
3. Squeeze the sides of the hinge cover 2 and remove it.
Note: Even though this hinge cover is not used with the Flat Panel Monitor Rack Mount Kit II, do not
discard it. Store it with the other monitor stand parts you remove for possible future use.
4. Gently push the stand cover 3 and slide it backwards until it is completely off the stand.
5. Disconnect the signal cable and power cord from the flat panel monitor. Carefully remove and save
the plastic cable clamp to free the power cord.
Note: The plastic cable clamp is reusable and is needed to secure the power cord after installing the
Flat Panel Monitor Rack Mount Kit II on the flat panel monitor.
Figure 2. Removing the plastic cable clamp
2
Copyright IBM Corp. 2001
Advertisement
Table of Contents
