Installing The New Monitor Stand; Removing The Hinges From The New Monitor Stand; Installing The Hinges On The Flat Panel Monitor - IBM rack mount kit II Installation Instructions Manual

Installing the new monitor stand

Refer to "Removing the existing flat panel monitor stand" on page 2 for instructions on how to remove the
existing stand from the flat panel monitor. Before installing the new stand, install the keyboard tray in the
rack cabinet according to the instructions that come with the rack cabinet or the keyboard tray option.
Note: The Flat Panel Monitor Rack Mount Kit II and keyboard tray require 3U of rack mounting space. If
the keyboard tray does not have at least 2U of clearance above it, relocate the keyboard tray
within the rack cabinet.
Use the following steps to install the Flat Panel Monitor Rack Mount Kit II:
1. Remove the cable cover 1 from the new monitor stand; then, remove the four screws (two per
hinge) that secure the hinges 2 to the stand.
Figure 4. Removing the hinges from the new monitor stand
2. Install the hinges on the flat panel monitor, using the six screws that you removed from the old monitor
stand.
Figure 5. Installing the hinges on the flat panel monitor
Note: Be sure to slide each hinge into place on the back of the monitor and align the holes in the
hinges with holes on the monitor.
4  Copyright IBM Corp. 2001