IMPORTANT! Use only a Power Wheels
rechargeable battery. Use of any other battery will damage your
vehicle. Make sure that you charge the battery for at least 18
hours using the enclosed Power Wheels
operating your vehicle for the first time. Charge the battery for
at least 14 hours after each use of the vehicle. Never charge the
battery longer than 30 hours. Failure to follow these instructions
may damage your battery and will void your warranty.
1
• Press the tab under the back edge of the seat and lift to
remove the seat.
Power Wheels
12 Volt Battery
Motor Harness
Connector
2
• Lift the battery retainer to access the battery compartment.
• Place the battery upright in the battery compartment.
• Plug the motor harness connector into the battery. Push firmly.
BATTERY INSTALLATION
12 volt lead-acid
®
®
12 volt charger before
Seat
Battery
®
Retainer
15
Battery Retainer
3
• Carefully lower the battery into the battery compartment.
The battery retainer slides over the battery to secure it.
Seat
B
4
• Fit the tab at the front of the seat into the slot near the drive
buttons
.
A
• "Snap" the tab at the back of the seat into the slot near the
rear of the vehicle
.
B
Drive Buttons
A
P9723b-0920