Rca Analog Installation - TV Ears 5.0 Speaker Quick Start Manual

RCA Analog Installation

Step 2.1
This step is an alternative to Step 2 on page 3. This step will
explain how to connect the TV Ears transmitter to your television,
satellite, or cable box using an RCA analog audio cord.
• If you cannot get to the back of your TV, you can also use these
instructions to install the system to your cable or satellite box.
• Be aware that the "Audio" ports on the front of your television are
typically "Audio In" ports and will not send audio to your headset.
1
Plug the dual end of the audio cord (red and black ends) into
the analog "Audio Out" ports on the back of the television,
satellite, or cable box.
2
Plug the single end of the audio cord into the port labelled
"Analog Audio In" on the back of the transmitter. The correct
port has a yellow border around it.
• TV Ears systems are mono systems. This means that you will still
hear sound through both the left and right earpieces even if you
only have the left or right audio connected.
• Your TV's audio settings may be set to "variable" or "fixed". If you
want to be able to control your TV volume level separate from your
TV Ears volume level, you will need to make sure your TV is set to
"fixed". Contact your TV manufacturer for assistance.
Analog Audio
3.5mm
4