Front Panel And Rear Panel Illustration - Nevir NVR-2090DU Instruction Manual

Front Panel and Rear Panel Illustration

1. Front panel
STANDBY Used to switch the set top box to on and off.
1
2 STANDBY INDICATOR: Used to visually show power state of the set top box, the green
LED will be light if turned on the set top box and the red LED will be light if the set top box
entered standby mode.
3 REMOTE CONTROL SENSOR: Used to receive the signal from the remote control.
4 USB: USB Jack, Support USB1.1.
5 CHANNEL UP/DOWN: Used to change channels without using the remote control.
Nevir S.A.
C/Alfonso Gomez,40-A
28037-Madrid-Espana
CIF: A-28966307
R R F F LOOP LOOP
R R F F IN IN
THROUGH THROUGH
1 RF IN : This socket connects to your external aerial.
2 RF LOOP THROUGH: This socket will bypass the RF signal to either your TV or another
3 COAXIAL: This socket connects to a coaxial socket on your surround sound system.
4 VCR SCART: This socket connects to either a VCR or other video system.
5 TV SCART: This socket connects to TV.
6 MAINS CABLE: This is used to connect to main power supply.
NVR-2090DU
DIGITAL TERRESTRIAL RECEIVER
(100-240V~ 50/60Hz 10W)
Digital Digital
MADE IN P.R.C.
Audio Audio
Coaxial Coaxial
VCR O O VCR O O
video system.
6 6
CHANNEL
Serial No.:
100-240V~
50/60Hz
TV TV