Design Guide; The Installation Space; Product Clearances; Side-By-Side Installations - Monogram ZDWT240 Installation Instructions Manual

Wine reserve and beverage center
Hide thumbs Also See for ZDWT240:
Table of Contents

Advertisement

THE INSTALLATION SPACE

Locate
Outlet
10-1/2"
9" Max.
34-1/2"-35"
1-1/2"
23-3/4" Min.
NOTE:
Handle and
handle standoff
depth is 1-3/4"
The cutout depth should be 24"
The cutout dimensions shown allow for a full door
swing and access to the pull-out racks when installed
as a built-in in standard 24" deep cabinets.
• The wine reserve and beverage center can be
installed freestanding.
• If installing between frameless cabinets, a 1/2" wide
filler strip or side panel may be needed on hinge
side. The filler strip will act as a spacer between the
case and adjacent cabinet door swing. The width
of the opening must include the filler panels.
NOTE: The door should protrude 1" beyond the
surrounding cabinets.
Additional Specifications
• A 120 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install a
properly grounded 3-prong electrical receptacle
recessed into the back wall as shown. Electrical must
be located on rear wall as shown. NOTE: GFI
(ground fault interrupter) is not recommended.

SIDE-BY-SIDE INSTALLATIONS

Increase storage capacity by installing two Monogram
beverage centers or wine reserves together. Or, for a
complete refreshment center, install any two of these
units together.
• A side-by-side installation requires at least a 47-1/2"
wide opening. No trim kits required.
• Products must operate from separate, properly
grounded receptacles.

Design Guide

24"
23-3/4"
34-1/2"
23-3/4"

PRODUCT CLEARANCES

The wine reserve and beverage center is factory set
for a 110° door swing.
When installed in a corner:
• Allow 4" min. clearance on the hinge side for the
90° door swing and to allow racks to slide out.
• Allow 10" minimum clearance on the hinge side
for a full 110° door swing.
10" Minimum
to Wall
110°
Choose the location:
• These products may be closed in on the top and
three sides as long as the front is unobstructed for
air circulation and proper access to the door.
• Do not install these products where the temperature
will go below 55°F (13°C) or above 90°F (32°C).
• Do not install where it will be subject to direct
sunlight, heat or moisture.
• These products are not designed to be stacked one
over the other.
Black or Stainless Steel Toekick Options
• These products are shipped with a black toekick
installed. An optional stainless steel toekick is also
supplied with each product. For shipping purposes,
the stainless steel toekick is secured to the back
or inside the unit.
34-1/2"-35"
15"
3
90° Door Swing
90°
4" Minimum
Locate
Outlet
10-1/2"
10-1/2"
24"
14"
9"
9"
1-1/2"
47-1/2" Min.
21-5/8"
23-5/8"
to Wall

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zdbt240

Table of Contents