Table Of Contents; Design Guide; Tools Required; Parts Supplied - Monogram ZDWI240 Installation Instructions Manual

CONTENTS
Important Information .............................................2, 3
Design Guide
Tools Required ..............................................................3
Parts Supplied ...............................................................3
Staining Wood Drawer Fronts ......................................3
Installing Custom Frame Panel ....................................3
The Installation Space ............................................. 4
Product Clearances ................................................. 5
Side-by-Side Installation ......................................... 5
Installation Instructions
Step 1, Remove Packaging ..................................... 6
Step 2, Reverse Door Swing ................................... 6
Step 3, Leveling ....................................................... 7
Step 4, Connect Power............................................ 7
Step 5, Slide Product into Cutout ............................ 7
Step 6, Set Temperature Controls ........................... 7
Custom Frame Panel Models .................................. 8

TOOLS REQUIRED

• #2 Phillips screwdriver
• Adjustable wrench

PARTS SUPPLIED

• Hardware for changing door swing
• Optional stainless steel toekick with screws and
spacers
• Left and right side hinge covers
• Top screw hole cover
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 55°F (12.7°C) because it will not run
often enough to maintain proper temperatures.
• Do not install the refrigerator where the tempera-
ture will go above 100°F (37°C) because it will not
perform properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
31-46122-7

Design Guide

STAINING WOOD DRAWER
FRONTS
The drawer fronts are unfinished cherry wood. During
use, oil from hands may accumulate and stain the wood.
• The drawer fronts may be stained and sealed to match
adjacent cabinetry. The tinted glass will make the
stained wood appear darker. A true color match can be
seen only when the door is opened.
• Apply the stain and sealer according to the manufac-
turer's instructions. To avoid unpleasant odor, keep the
door open to ventilate and allow the stain/sealer to dry
completely before using the product.
INSTALLING THE CUSTOM FRAME
PANEL
Go to page 8 for custom frame panel size, depending on
your cabinet size and style.
• Install a custom handle of your choice onto the custom
panel before the panel is secured to the door.
• The custom panel should be installed before sliding the
product into the installation location.
3