Table of Contents
Advertisement
STEP 2 LEVEL
• Use an adjustable wrench to turn the leveling legs
and raise or lower the product.
• Adjust carefully; the product should be level and
plumb with cabinetry, and should align with adjacent
toekick height.
Turn Right to Lower
Turn Left to Raise
STEP 3 CONNECT POWER
• Connect power cord plug to a properly grounded
receptacle.
• Check to make sure power is on by opening the door
to see if interior light turns on.
Installation Instructions
STEP 4 SLIDE PRODUCT INTO
THE CUTOUT
WARNING:
push against the glass door when moving or installing
these products. Pressure against the glass door will
cause damage.
AVERTISSEMENT :
jamais et ne mettez jamais de pression sur la porte
en verre quand vous déplacez ou installez ces
produits. Toute pression sur le verre occasionnera
des dommages.
• Carefully slide the unit into the opening.
Be careful not to entangle power cord.
• Make certain that the door protrudes 1" beyond
the surrounding cabinets.
• Check again to be sure the unit is level.
STEP 5 CHANGE THE TOEKICK
• The stainless steel toekick is secured to the back
of the product or inside.
• The toekick has a
cutout on the left
and right
sides.
Remove
the plug
on the
left side
and
reinstall
on the
right side. If
you choose to
install the stainless
steel toekick, reinstall the plug on the right side
of that toekick.
• Install original screws and spacers or screws and
spacers supplied with the stainless steel toekick.
Install screws through the spacer standoff, toekick
and into the base as shown.
STEP 6 SET TEMPERATURE
CONTROLS
• The temperature controls are preset. Refer to
the Owner's Manual for more information.
Allow 24 hours for temperature to stabilize.
5
Do not apply pressure or
Ne poussez
Move Fill
Plug to
Right Side
Advertisement
Table of Contents
