Table Of Contents; Design Guide; Tools Required; Parts Supplied - Monogram ZDWI240 Installation Instructions Manual

CONTENTS
Important Information .................................................................... 2, 3
Design Guide
Tools Required ............................................................................................. 4
Parts Supplied .............................................................................................. 4
Staining Wood Drawer Fronts ........................................................... 4
Installing Custom Frame Panel ......................................................... 4
The Installation Space .............................................................. 4, 5
Product Clearances ........................................................................ 5
Side-by-Side Installation ............................................................. 5
Installation Instructions
Step 1, Remove Packaging.......................................................... 6
Step 2, Reverse Door Swing ........................................................ 6
Step 3, Leveling ................................................................................. 7
Step 4, Connect Power .................................................................. 7
Step 5, Slide Product into Cutout .............................................. 7
Step 6, Set Temperature Controls ............................................ 7
Custom Frame Panel Models ..................................................... 7

TOOLS REQUIRED

• #2 Phillips screwdriver
• Adjustable wrench

PARTS SUPPLIED

• Hardware for changing door swing
• Optional stainless steel toekick with screws and spacers
• Left and right side hinge covers
• Top screw hole cover

STAINING WOOD DRAWER FRONTS

use, oil from hands may accumulate and stain the wood.
• The drawer fronts may be stained and sealed to match
adjacent cabinetry. The tinted glass will make the
stained wood appear darker. A true color match can be
seen only when the door is opened.
• Apply the stain and sealer according to the manufac-
turer's instructions. To avoid unpleasant odor, keep the
door open to ventilate and allow the stain/sealer to dry
completely before using the product.
INSTALLING THE CUSTOM FRAME PANEL
Go to page 6 for custom frame panel size, depending on
your cabinet size and style.
• Install a custom handle of your choice onto the custom
panel before the panel is secured to the door.
• The custom panel should be installed before sliding the
product into the installation location.

Design Guide

THE INSTALLATION SPACE
NOTE:
Handle and handle
*For a standard installation of Custom-Framed unit: The
product must be installed so that the front face will project 2"
forward of adjacent cabinets. This position will allow a full door
swing and prevent interference with adjacent cabinetry. The
opening between cabinets must be 23-3/4" minimum.
*For a standard installation of Stainless Steel unit: The product
must be installed so that the front face will project 1-3/4"
forward of adjacent cabinets. This position will allow a full door
swing and prevent interference with adjacent cabinetry. The
opening between cabinets must be 23-3/4" minimum.
a spacer between the door case and adjacent cabinets and will
prevent interference with the cabinet door swing. Recess the
the front edge of the product case (behind the gasket). The width
a spacer between the door case and adjacent cabinets and
will prevent interference with the cabinet door swing. Recess
the front edge of the product case (behind the gasket). The width
• The wine chiller, wine reserve and beverage center can
be installed freestanding.
• A 120 volt 60Hz., 15 or 20 amp power supply is required. An
individual properly grounded branch circuit or circuit break-
er is recommended. Install a properly grounded 3-prong
electrical receptacle recessed into the back wall as shown.
Electrical must be located on rear wall as shown.
NOTE: GFI (ground fault interrupter) is not recommended.
4
Install a
Install a