Installation And Electrical Connection - Kenwood Microwave Oven User Manual

MICROWAVE OUTPUT POWER
The power output of your oven in WATTS is marked on the back of your appliance under the heading MICRO
OUTPUT. When you consult tables, always refer to the output of your oven!
It will also be useful when you consult microwave recipes.
1.3 INSTALLATION AND ELECTRICAL CONNECTIONS
1) Unpack the oven and remove the protective packaging containing the turntable (H), turntable support (I)
and accessories. Check that the turntable spindle (D) is fitted correctly into the
recess in the centre of the turntable.
2) Clean the inside of the oven with a soft, damp cloth.
3) Check that the oven has not been damaged during transport. Check in parti-
cular that the door opens and closes properly.
4) Place the oven on a flat, stable surface at a height of at least 85 cm and out
of reach of children as the door may become very hot during cooking.
5) When positioning the oven on the worktop, take care to maintain a gap of
approx. 5 cm between the oven and the walls to its rear and sides and a
gap of at least 25 cm above the oven (fig. 6).
6) Do not block the air intake vents. In particular, never place anything on top of the
oven and make sure the air and steam outlet vents (on the top, bottom and rear
of the appliance) are ALWAYS FREE (fig. 7).
7) Place the turntable support (I) in the centre of the circular housing and rest the
turntable (H) on top. The spindle (D) must be inserted into the housing in the cen-
tre of the turntable.
N.B. Do not position the oven on or near sources of heat (for example on top
of a refrigerator) (fig. 8).
8) The appliance must be connected to a socket with a minimum current rating of
16A. Make sure the household main switch has a minimum rating of 16A to
avoid it tripping unexpectedly during operation of the oven.
9) Position the oven in such a way that the power plug and socket are easily acces-
sible.
10) Before you switch on the oven, check that the mains voltage corresponds to that specified on the oven rating
plate and that the power socket is properly earthed. The manufacturer declines all responsibility for failure to
observe this safety precaution.
11) The majority of modern electronic appliances (TV, radio, stereo systems etc) are shielded from radio fre-
quency (RF) signals. Certain electronic appliances may not, however, be shielded from radio frequency sig-
nals deriving from a microwave oven. You should therefore keep a distance of at least 1-2 metres between
these appliances and the operating oven.
CHAPTER 1 – GENERAL
On some models, the microwave output power is also given in this symbol, reproduced
on the control panel.
25 cm
AIR
USCITA
OUTLET
AIR
ARIA
ENTRATA
INLET
ARIA
AIR
USCITA
OUTLET
ARIA
5 cm
fig. 6
fig. 7
fig. 8
33