Kenwood TS-590SG Setting Manual page 25

Operations Audio transmissions are noisy or
small. Where should I check and
adjust?
I want to hear the beeps and voice
guidance audio of the transceiver
from the PC speaker. Is this
possible.
Can I set the PC to sleep mode
while I'm not using the host station?
When a fixed time has elapsed
without the host station being used,
the host station PC screen turns
OFF, and responses to connection
requests from the remote station
cannot be made.
If there is a connection request from
the remote station while the host
station is not being used, a
message is displayed and
connections to the host station are
disabled.
An audio I/O between the host
station PC and transceiver cannot
be performed correctly.
The modulation is not performed
even when the ARCP-590G "Send"
button is pressed.
Question
24
Answer
Adjust the ACC2 audio level in menus
73 and 74.
Try changing the sound function driver
version.
If using the sound functions in
comprehensive chipsets, try an
independent sound card or USB sound.
Set using the "Mixing beep tones for
ACC2/ USB audio output" in menu 75.
Recovery from sleep mode takes time.
During sleep mode recovery, responses
to the remote station cannot be returned
until there is a time out. Therefore, we
recommend you do not set the host
station to sleep mode.
Is the Windows energy save mode
operating, and has the power supply to
the host station HDD been disabled?
When the HDD power supply is turned
OFF, the HDD power supply is turned
ON to respond, but at this time nothing
can be returned until the response to
the remote station has timed out.
Consequently, set the Windows power
supply function settings so that the HDD
power supply does not turn OFF.
Check that a default device is specified
as the device connected to the
TS-590SG using the Windows sound
settings on the host station PC.
Check that the same path as the
modulation path wired between the
transceiver and the PC has been
selected using the ARCP-590G "Setup
TX Control" menu.