Maintenance - Central Pneumatic 47016 67181 Owner's Manual & Safety Instructions

Delayed or inadequate cleaning will permanently clog the Spray Gun.
Latex paint hardens quickly and permanently inside Spray Gun.
User-Maintenance Instructions
procedures not specifically explained in this manual
must be performed only by a qualified technician.
TO pREVENT SERIOUS INJURY:
Detach the air supply and safely discharge any residual air pressure in the tool
before performing any inspection, maintenance, or cleaning procedures.
TO pREVENT SERIOUS INJURY FROM TOOL FAILURE: Do not use damaged equipment.
If abnormal noise, vibration, or leaking air occurs, have the problem corrected before further use.
Inspection
Note: These procedures are in addition to the regular checks and maintenance
explained as part of the regular operation of the air-operated tool.
BEFORE EACH USE, inspect the general condition of the tool. Check for:
• loose screws,
• misalignment or binding of moving parts,
• clogged nozzle,
• damaged air supply hose,
Cleaning
Solvent Selection
Follow the paint manufacturer's recommendations for
cleaning, solvent type, and disposing of used solvent.
IMpORTANT: Do not use mineral spirits
with latex paints, doing so will make the
paint very difficult to remove.
After each use:
1. Empty the Cup and clean it with the solvent.
2. Fill the Cup with solvent and spray it through
the Spray Gun into a container, while shaking
the Spray Gun. Once the Cup is empty, repeat
the process until the solvent comes out clean.
3. Disconnect from the air source.
4. After disconnecting, point the Spray Gun into
the spent solvent container and squeeze the
Trigger again to make sure no air remains.
Air Supply Maintenance
Every day, perform maintenance on the air supply according to the component manufacturers' instructions.
Storage
Store in a dry, secure area out of reach of children.
Page 12
NOTICE
Clean the Spray Gun IMMEDIATELY after EVERY use.
For technical questions, please call 1-888-866-5797.
• cracked or broken parts,
• damaged electrical wiring, and
• any other condition that may affect its safe operation.
5. Remove Nozzle and soak it in solvent
until it is clean. Use old toothbrush and
toothpicks to remove any paint.
CAUTION: Do not immerse Spray Gun.
Note: Do not use metal objects to clean the
Nozzle to prevent damage to the passages.
6. Inspect fluid needle and make sure it is not bent. If
it is bent, have it replaced by a qualified technician.
Use appropriate solvent (see Solvent Selection,
7.
left) to wipe down Spray Gun body.
8. Lubricate Spray Gun after cleaning. A non-silicon
oil or a light lubricant may be used on
threaded connections before storing.
Solution Disposal
After cleaning, dispose of cleaning solution
according to the solution manufacturer's directions
and local hazardous waste standards.
Item 47016 67181