Jøtul F 371 Installation And Operating Insctruction Manual page 12

ENGLISH
Fig. 14
6. Adjust the height of the product if necessary, using the
adjustment screws beneath the leg (fig. 14 A).
Fig. 15
7. Replace the cover for the external air supply (fig. 15 A).
Installation without external air
1. Attach the base to the burn chamber using the 4 screws (M8
x 30 mm) from the bag of screws (fig. 13A).
2. With the help of another person, carefully raise the product
and position it correctly over the external air supply.
3. Adjust the height of the product if necessary, using the
adjustment screws beneath the leg (fig. 14A).
4. Replace the cover (fig. 15 A).
12
Jøtul F 375 - Cast iron base with glass door
1. Assemble the cast iron base as described under point
"Jøtul F 371 - cast iron base".
Fig. 16
2. Attach the hinge for the glass door to the base using the
M6 x 20 mm screws, which are in the bag of screws for the
glass door (fig. 16 A).
3. Insert the spring between the threaded holes and the hinge
before tightening the screws (fig. 16B).
Fig. 17
4. Screw the other end of the spring firmly in position (fig. 17 A).
5. Attach the door damper to the inside of the glass door in the
bottom right-hand corner (fig. 17 B).
NB! There must be an even gap between the door and the base
to allow the door to hang straight. Adjust the door if necessary,
by tightening or loosening the two screws (fig. 17 C).