Pre-Fab Fireplace Insert Instructions - New Buck Corporation 60 Installation Manual

PRE-FAB FIREPLACE INSERT INSTALLATION
MANTEL
AND/eR SUPPOR1S
CCMBUSTlBLE PROJECl1NG
MORE
THAN 3/4"
12"
MIN
i
1
I
-
1
.....
j/
/
-
-
-
"
-
INSERT lDP
-
i - -
I
H
-
I - -
I I
§
-
II
,.--
,
-
6
H
Mll\L SIDES
&
TOP
TO COMBUSTlBLE MA!ERIAL
Figure 7
IMPORTANT:
FRCtH
\~EW
READ ENTIRE MANUAL BEFORE ATTEMPTING TO INSTALL
THESE UNITS.
1. For clearance see Figure 7.
2. Failure to follow instructions will result in improper burning
of unit and voids all warranties and liability of manufacturer.
NOTE: Do not allow the combustion and ventilation air to be
obstructed. Combustion air enters at the bottom of each unit.
A. Model 40 pre-fab fireplace inserts must be installed on
legs long enough to leave at least 1" air space from outer
skin to bottom of fireplace.
B. Model 60 pre-fab fireplace inserts must be installed on
*"
material provided with kit, to leave at least
*"
air
space from outer bottom to bottom of fireplace. Trim
panels may be connected directly to side of unit.
C. Model 25 may be installed in any pre-fab fireplace that
will accept its height. Trim panels must be installed
BEHIND slots on outer skin.
3. All units must be vented with 4" pipe from top of unit to
entire height of existing chimney.
4. Pre-fab fireplace inserts must be equipped with manual igniter.
See example B for light up and shut down instructions.
CAUTION:
NOTE:
Read I - 7, page 10 carefully before lighting your unit
for the first time.
TRIM PANELS CANNOT COVER EXISTING COOLING OR LOUVERED VENTS
ON ANY PRE-FAB FIREPLACE.
12