Panasonic CS-F14DB4E5 Service Manual page 74

2 Route the joint cord for wiring and connect it to P.C.B terminal <CN-DISP> in the control box of the indoor unit.
1. Route for wiring the cord as shown in the figure to the right.
2. Remove the control box cover by removing the two fixing screws and connect the joint cord to P.C.B terminal <CN-DISP> in
the control box.
10.7.4. Address setting for wireless remote controller and receptor unit (only when using
more than one indoor unit)
• Only the air conditioner units which receptor unit address numbers match the remote controller address number can be oper-
ated.
• At the time of shipment from the factory, the address numbers for both the wireless remote controller and the receptor unit are
set to "1". (When using only one indoor unit, the indoor unit can be used without changing the factory default settings.)
Press the address setting switch with a ballpoint pen or similar object to change the address setting.
The address number displayed on the LCD change in the order [ADDRESS 1] → [ADDRESS 2] → [ADDRESS 3] → [GROUP] →
[ADDRESS 1] each time the switch is pressed.
74