Installing The Dim Module - Hectronic H6052 Hardware Reference Manual

Installing the DIM Module

Note:
The system board used in the following illustrations may not resemble the actual one. These
illustrations are for reference only.
1. Make sure the PC and all other peripheral devices connected to it has been powered
down.
2. Disconnect all power cords and cables.
3. Locate the SODIMM socket on the system board.
4. Note the key on the socket. The key ensures the module can be plugged into the
socket in only one direction.
5. Grasping the module by its edges, align the module into the socket at an approximately
30 degrees angle. Apply firm even pressure to each end of the module until it slips
down into the socket. The contact fingers on the edge of the module will almost
completely disappear inside the socket.
H6052 Hardware Reference Guide
11