System Memory - Hectronic H6052 Hardware Reference Manual

Important:
Electrostatic discharge (ESD) can damage your board, processor, disk drives, add-
in boards, and other components. Perform installation procedures at an ESD
workstation only. If such a station is not available, you can provide some ESD
protection by wearing an antistatic wrist strap and attaching it to a metal part of the
system chassis. If a wrist strap is unavailable, establish and maintain contact with
the system chassis throughout any procedures requiring ESD protection.

System Memory

The system board is equipped with two 204-pin SODIMM sockets that support DDR3
memory modules.
Important:
When the Standby Power LED lit red, it indicates that there is power on the board.
Power-off the PC then unplug the power cord prior to installing any devices. Failure
to do so will cause severe damage to the board and components.
H6052 Hardware Reference Guide
10
DDR3
socket
Standby
Power LED