Dvd Player - Kenwood VR-3100 Connection And Setup Manual

Chapter One : Connecting Your Devices
Connecting Your MD Recorder or Primary Tape Deck, continued
Do not plug in the receiver to AC power until you
have connected all your devices.
This section focuses on the connections from your
MD recorder or tape deck to the VR-3100/VR-3090/
KRF-V9992D. Please refer to your MD recorder or
tape deck's instructions for more detail about its
connection jacks and capabilities.
Each set of instructions in this section shows one of
several possible variations on connecting your MD
recorder or tape deck. For further assistance on
optional configurations, contact the store where you
purchased your MD recorder or tape deck.
To Connect an MD Recorder:
1 . Connect the audio cable from the MD recorder's
Play OUT jacks to the receiver's MD/TAPE 1 PLAY
IN jacks as shown to the left.
2 . Connect the audio cable from the MD recorder's
Rec IN jacks to the receiver's MD/TAPE 1 REC
OUT jacks, as shown to the left.
3 . (VR-3100 and KRF-V9992D only) Remove the
cover from the receiver's OPTICAL DIGITAL OUT
jack, then connect the optical digital cable from
the MD recorder's REC IN jack to the receiver's
OPTICAL DIGITAL OUT jack as shown to the
l e f t .
You only need to connect to the digital out jack
if you will be recording from sources that are
connected to a digital in jack, such as a CD or

DVD player.

4 . If you are connecting a Kenwood MD recorder,
connect the system control cable from the MD
recorder to the receiver. Be sure that the SL16/
XS8 switch on the receiver is set to SL16. (MD
recorder only supports SL16 system control
mode.)
If you are connecting more than one Kenwood
device with a system control cable, see "What if I
Have Several Kenwood Devices (System Control
Chaining)?" on page 28.
5 . Go to "Noting Your Devices" on page 3 and note
which jacks you used to connect your MD
recorder. In addition, note the brand name and
model number of the MD recorder.
Audio-Video Receiver VR-3100/VR-3090/KRF-V9992D
To Connect a Primary Tape Deck:
1 . Connect the audio cable from the tape deck's
Play OUT jacks to the receiver's MD/TAPE 1 PLAY
IN jacks as shown to the left.
2 . Connect the audio cable from the tape deck's Rec
IN jacks to the receiver's MD/TAPE 1 REC OUT
jacks as shown to the left.
3 . If you are connecting a Kenwood tape deck with
system control, connect the system control cable
from the tape deck to the receiver. Be sure that
the SL16/XS8 switch on both the tape deck and
the receiver is set appropriately.
If you are connecting more than one Kenwood
device with a system control cable, see "What if I
Have Several Kenwood Devices (System Control
Chaining)?" on page 28 of the Connection and
Setup Guide.
4 . Go to "Noting Your Devices" on page 3 and note
which jacks you used to connect your tape deck.
In addition, note the brand name and model
number of the tape deck.
To Connect a Secondary Tape Deck
See "Connecting Your Secondary CD Player or Tape
Deck" on page 20.
1 9