General Notice; External Usb Storage Media - Kathrein UFS 910 Function Manual

Application of external usb storage media for recording and playback

Hide thumbs Also See for UFS 910:

GENERAL NOTICE

KATHREIN cannot be held liable for damage, loss of data or consequential loss of any kind (e.g. loss of

proﬁ t, interruption of production, loss of data and information, or other detriment to assets) resulting from

the use or non-usability of this KATHREIN product, even where KATHREIN has pointed out the possibility

of such loss occurring.

REQUIRED FIRMWARE UFS 902/910

The ﬁ rmware used on the UFS 902 must be version "V1.02".

The ﬁ rmware used on the UFS 910 must be version "V1.04".

If this ﬁ rmware has not been installed on your UFS 902/910, you can either update the ﬁ rmware via satellite

as described in your UFS 902/910 manual, or download it from the following Internet website:

"http://www.kathrein.de". Firmware can be found under "Service" → "Software and Downloads" → "Receivers"

→ "UFS 902"/"UFS 910" → "Software and Firmware". For instructions on how to upload the software to your

receiver, please see the Update Guide link on our Internet website (ufs910_update_guide.pdf).

To record programmes with the UFS 902/910, an external USB storage medium is required

(e.g. external hard disk drive with USB connection). The device can be connected on one of the two USB

2.0 interfaces on the receiver rear panel (see image below). The USB interface on the receiver front

panel has not been designed for connection of USB storage media, it is only intended for ﬁ rmware

uploads.

Please note that the USB 2.0 socket on the receiver only has an output current of

500 mA. For some hard disk drives, this current is insufﬁ cient for smooth operation.

To guarantee optimal supply to the hard disk, you can either use a hard disk drive with

a built-in power supply or you can insert a USB 2.0 hub with its own power supply

unit.

After connecting the external storage medium to one of the two USB 2.0 interfaces, the symbol

appear on your receiver's display (only at UFS 910). Subsequently, the registration procedure will follow.

As soon as registration has been successfully concluded, the symbol

nal storage medium can now be used to make recordings through the UFS 910.

Press the

button to check if the UFS 902 initialised successfully. If the screenshot "Recording Archive"

appears, initialisation was successful.

UFS 902/910

HDD

will also be displayed. The exter-

USB

will

Ufs 902