Advertisement
SETTING UP THE TEAM SELCOM
1. AERIAL CONNECTION :
The PL259 plug of the aerial cable ( coax ) is connected to the SO239 antenna
socket ( 17 ) ANT on the rear panel. Make sure that the plug is firmly tightened
and properly soldered to the 50 ohm coaxial cable. Unsatisfactory connections
can damage the radio and will reduce the range of operation.
2. MICROPHONE :
Insert the 6 pin plug of the curl cord of the microphone into the microphone con-
nector ( 5 ) on the left side of the front panel. Note it will only go in one way
round. Tighten the plug firmly to secure it. No transmission and receiving of the
SelCom 4000 is possible without the microphone.
3. POWER SOURCE :
Before connecting the power source to the DC connector ( 19 ) the device must
be switched off by turning the volume knob ( 2 ) VOLUME / ON counterclockwise
as far as the stop and hearing a switching sound. The fused DC power cable
supplied, is used to make the necessary power connection to the transceiver.
The unit is designed to operate from a battery source of 13.8 volts DC, employ-
ing negative ground electrical system.
BLACK
RED
For base-station operation connect the radio to a suitable power supply ( 13.2V / 1.5A ).
OPERATION OF THE
After the antenna, the microphone and the power source have been connected,
radio operation can be undertaken.
1. SWITCHING ON [ VOLUME / ON ] :
Switch the radio on by turning the volume control ( 2 ) VOLUME / ON clockwise
and adjust it to a comfortable listening level. If the transceiver is on a clear chan-
nel and not muted by the squelch function a noise should be heard from the
speaker now. The back illumination of the display ( 3 ) and the front panel will
light up. When the unit is switched on the first time or after being disconnected
for a longer period the first channel will be channel 9. The display will show [ 9,
FM and SRF ]. If the power source is not disconnected after switching off the
settings and functions will be stored ( memory backup ). All correct entries will be
confirmed by a receipt tone.
connect to ( - ) MINUS of the car battery / GROUND
connect to 12 volts ( + ) PLUS of the car battery. This wire
can be connected to the ignition to prevent the use of the
radio while the ignition is off.
TEAM SelCom 4000
- 12 -
4000
Advertisement
